Laboratory Manual for Electronic Devices and Circuits
 |
Each laboratory investigation consists of:
- a title
- an introduction that briefly describes the investigation
- a list of required equipment and components
- circuit diagrams and connection diagrams
- a step-by-step procedure to be followed
- a laboratory record sheet for recording data
- an analysis section for processing the data
Typical test results are offered in the Instructors Manual. |
Page Samples:
Click any of the images below to enlarge.
Contents:
Preface
- Semiconductor Diode Characteristics
- Diode Rectifier Circuits
- Rectifier DC Power Supply
- Zener Diode
- Diode Clipping Circuits
- Diode Clamping Circuits
- BJT Characteristics
- Characteristic Plotting on an XY Recorder
- BJT Bias Circuits
- BJT Switching Circuits
- BJT Common-Emitter Circuit
- BJT CC and CB Circuits
- JFET Characteristics
- JFET Bias Circuits
- Basic JFET Circuits
- Capacitor-Coupled BJT Amplifier
- Direct-Coupled BJT Amplifier
- DC Feedback Pair
- Capacitor-Coupled BIFET Amplifier
- Direct-Coupled BIFET Amplifier
- Differential Amplifier
- Two-Stage NFB Amplifier
- Differential-Input Amplifier with NFB
- Emitter-Current Feedback Amplifier
- Op-Amp Biasing and Parameters
- Voltage Followers and Noninverting Amplifiers
- Inverting Amplifiers
- Summing and Difference Amplifiers
- Instrumentation Amplifier
- Op-amp Schmitt Trigger Circuits
- Op-amp Frequency Response and Compensation
- Sinusoidal Oscillators
- Square and Triangular Wave Generators
- Series Voltage Regulator
- BJT Output Power Amplifier
- MOSFET Output Power Amplifier
- SCR Characteristics and 90° Phase Control
- SCR and TRIAC Control Circuits
- UJT and PUT Circuits
- Photoconductive Cell, LED and Solar Cell
- Optocouplers
|
)
)
)
)